Installation manual

-8-
10. Programming Remote Transmitters
Prior to programming new remote transmitters to the security system, make sure to
have the desired transmitters ready.
To Enter Remote Transmitter Programming:
1. Turn the ignition ON, OFF, ON, OFF, and leave ON.
2. Press and hold the Valet/Override switch for 5 seconds.
The siren will chirp once.
3. Press the Lock button on the transmitter.
The siren will chirp once.
4. Press the Lock button on the transmitter again.
The siren will chirp twice.
5. Repeat steps 3 and 4 for each additional transmitter.
6. Turn OFF the ignition when transmitter programming is complete.
The siren will chirp 3 times.
11. Arming Mode Selection
1. Turn the ignition On.
2. Press * button on the transmitter until desired Arming Mode is selected:
One Chirp: Passive arming with chirp confirmation.
Two Chirps: Active arming (default setting).
Three Chirps: Passive arming without chirp confirmation.
3. Turn Off the ignition when the Arming Mode selection is complete.
ms2100.qxd 4/29/2003 3:51 PM Page 8