Owner’s manual & Installation manual 使用說明書和安裝說明書 TTX754 CeNET TV TUNER (PAL) CeNET電視調諧器(PAL制式) TTX754 MODEL CeNET TV Tuner 12V VHF UHF GROUND 45.75MHz-224.25MHz 471.25MHz-855.
English Thank you for purchasing this Clarion product. • Please read this Owner’s manual & Installation manual in its entirety before proceeding with wire connection and installation. • After reading this manual, be sure to keep it in a handy place (e.g., glove compartment). If you sell the motor vehicle, please leave the manual in it so that the new owner can use it.
• This equipment uses DC 12 V only. Do not use this equipment on 24 V vehicles such as large trucks. • If a problem occurs such as entry of a foreign object, water gets into the tuner, or it produces smoke or strange smells, stop using the tuner immediately, and consult your dealer. ■ Tuner Handling • Disconnecting the cables while the system is operating may cause a system breakdown. Always turn off the power (ACC-OFF) before you disconnect the cables.
English 3. SET COUNTRIES LIST The TV area function can be used to set the following country areas. No. 0 1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 Set Countries Display Title ALBANIA AUSTRIA BELGIUM BOSNIA I H CZECH DENMARK FINLAND GERMANY HUNGARY ICELAND IRELAND ITALY NETHERLNDS NORWAY PORTUGAL RUMANIA SLOVAKIA SLOVENIA SPAIN SWEDEN SWITZERLND TURKEY UK AFGHAN. ALGERIA ANGOLA AUSTRALIA BAHRAIN No.
English 4. SPECIFICATIONS Reception channels: VHF CCIR 2 to 12ch UHF CCIR 21 to 69ch Antenna input: 75 Ω unbalanced voltage: 14.4 V Grounding: Negative terminal grounding Power consumption: 0.4 A or less External dimensions: 178 mm (Width) ✕ 25 mm (Height) ✕ 100 mm (Depth) 0.5 kg 6.6 100 Weight: 178 25 * The specifications and design may be subject to change without prior notice due to improvements.
English 5. TROUBLESHOOTING The following symptoms may not be the result of a breakdown, so perform the remedy suggested below before contacting your Dealer for repairs. Symptom No power Cause Wiring is incomplete. Remedy Check the wiring method in the manual again, then connect the wiring properly. No image Parking brake is not engaged. Check that the parking brake is engaged completely. Unclear image from rear seat monitor Image output for front and rear is connected in reverse.
English 6. INSTALLATION CAUTION • Disconnect the battery negative cable before connecting the wiring. • If you are making holes in the vehicle body in order to install the unit, first confirm the position of pipes, tanks and electrical wiring to avoid contact and interference. • When installing the wiring for connection cords on a vehicle equipped with airbags, do not install the wiring where it may affect the airbag system. • Do not cover the ventilation holes and heat-radiating parts of the tuner.
English 8. WIRING CONNECTIONS Connect the unit as follows. Notes: *1 Connect the cable to the terminal of equipment (center unit) that is connected by connection cables (CeNET cable) with the L-shaped terminals. *2 Connection requires a CCA-389 conversion cord (RCA3P → mini DIN8P) which is sold separately. *3 If you are connecting an antenna other than a 4 system diversity antenna, connect it to the MAIN terminal on the far right.