Car Video System User Manual

English
26
NX702
1. Insert an USB device into the USB cable.
When connecting an USB device, the unit
willreadthelesautomatically.
2. To remove the USB device, you should
first select another source or turn off
thepower,  in orderto avoiddamaging
the USB device. Then take off the USB
device.
3. To a cc e ss an U SB d ev i c e al r ea dy
connected to the unit, long press [ MENU
ALL ] button to enter main source menu,
then select [USB] to enter USB mode.
If [USB] is not on the current source menu,
touch [-] buttons on the bottom of the
screen, or hold the center of screen and
dragleft/righttoshowmoreicons.
1. Press [OPEN] button toslide down the
panel. Insert an SD card into the card slot
located on the left side of the panel.
 Wheninsertinga card,the unit willread
thelesautomatically.
2. Toremovethecard,youshouldrstselect
anothersource or turnoffthe power,in
order to avoid damaging the card. Press to
pop it out, then take off the card. Close the
panel.
3. To access an SD card already inserted in
the unit, long press [ MENU
ALL ] button
to enter main source menu, then select
[SD] to enter SD mode.
If [SD] is not on the current source menu,
touch [-] buttons on the bottom of the
screen, or hold the center of screen and
dragleft/righttoshowmoreicons.
Accessing an USB
Accessing an SD Card
8. SD/USB OPERATION