User Guide

OHM653 5
Note:
• The OHM653 remote is always required to control the monitor -
source unit remote controls do not operate the OHM653.
To use remote controls with the OHM653, point the remote at
the face of the deployed screen when pressing the buttons.
The RCBOHM653 Remote Control
Before use, the 2 (AAA) batteries included must be inserted
into the remote control. Make certain that the batteries are
inserted according to the (+) and (-) marks on the inside of
the battery compartment.
Slide the battery door off and insert the batteries as shown.
+
+
+
+
-
-
-
-
Notes:
• The batteries should last about 6 months in normal use. Remove
leaking batteries immediately. Store the remote in a cool dark
place when not in use.
PICTURE
SELECT
WIDE/NORMAL
POWER
AV1/AV2
OHM-653
PICTURE
SOURCE
ADJUST UP
ADJUST DOWN
POWER
WIDE/NORMAL
The [POWER] button turns the OHM653 on and off.
Notes:
• Even after the OHM653 is switched on, the screen remains dark
until a video signal is detected.
• When the ignition switch is turned off, the OHM653 automatically
shuts off. The next time the ignition switch is turned on, the
OHM653 will remain off until the [POWER] button is pressed.
The [SOURCE] button selects between the two sets of audio/
video inputs of the OHM653.
Note:
• If only one of the inputs is used, the screen will remain dark when
the unused input is selected.
OHM 653 122302.p65 12/23/02, 10:41 PM5