INTRODUCTION The Clarion PEQ460 is a full-featured four-band parametric equalizer specifically designed for the mobile environment.
18dB per octave electronic crossover that is continuously variable from 35Hz to 250Hz. Built into the PEQ460 is an auxiliary input that allows use with portable devices (such as an MP3 player) or a video system. 1. Volume Control 2. Aux Switch 3. Fader Control 4. Sub Frequency Adjustment 5. Low Frequency Adjustment 6. Mid Frequency Adjustment 7. High Frequency Adjustment 8. Low-Pass Frequency Adjustment 9. Sub Level Control 10. Power Plug 11. Sub Output 12. Radio Input 13. Aux Input 14. Rear Output 15.
auxiliary source. • Equalizer Band Center Frequency Adjustment - This adjustment allows you to change the center frequency for each of the four frequency bands. • Equalizer Gain Controls - The parametric controls allow individual gain adjustment for each of the four frequency bands. • Low Pass Frequency Adjustment - This allows the subwoofer crossover frequency to be adjusted between 35Hz-250Hz. • Subwoofer Level Control - This is the volume control for the subwoofer.
1. Check clearances on both sides of a planned installation before drilling any holes or installing any screws. 2. When routing RCAcables, keep them away from power cables and output speaker wires. 3. Do not allow liquids or foreign objects to enter the unit. 4. If the unit should become wet, turn off all power and ask your authorized Clarion dealer to clean or service the unit. WIRING PRECAUTIONS Read all wiring precautions. If you are not sure of the connections, contact your authorized Clarion dealer.
5. If you are using a source unit, without a remote turn-on lead, the PEQ460 can be turned on with a switched accessory lead. You can find this accessory power source in the factory harness at the back of the radio. It is the lead that turns on and off with the key. SYSTEM SET-UP Setting System Volume After completing the system wiring, follow the steps below to properly adjust the PEQ460. 1. Turn the master volume control on the PEQ460 and the amplifier gain controls to their minimum setting. 2.
TROUBLESHOOTING Problem Unit does not work; no lights. Solution • Power wires are not connected. Check battery and ground wiring at unit; check battery connections. Problem Sound is distorted. Solution • Source unit volume is set too high. Reduce source unit volume. • EQ controls are set too high. Turn EQ controls to the center position and listen for distortion again. If problem still occurs, see your authorized Clarion dealer. • Speakers may be damaged. Consult your authorized Clarion dealer.
661 W. Redondo Beach Blvd. Gardena, CA 90247 1-800-GO-CLARION www.clarion-usa.com PEQ460-10 Rev.
