MS3001_owner's.
MS3001_owner's.qxd 9/10/99 5:27 PM Page 2 ongratulations on your purchase of the Ungo Security System. This Ungo Security System was designed in the heart of California’s high-tech “Silicon Valley” by Ungo Security Corporation, a subsidiary of Clarion Corporation. Since its founding in 1975, Ungo has been recognized as a pioneer and long time industry leader in vehicle security. C Please read this manual thoroughly to familiarize yourself with your system’s components and operation.
MS3001_owner's.qxd 9/10/99 5:27 PM Page 3 Table of Contents 1. About Your System . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . Page 1 2. Remote Transmitters Remote Transmitter Layout . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .Page 2 Two Car Operation . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
MS3001_owner's.qxd 9/10/99 5:27 PM Page 1 About Your Ungo Security System Ungo Security Systems are state-of-the-art vehicle protection systems equipped with features designed to: ❐ Deter potential intrusions to the vehicle by continually flashing the system LED status indicator while the system is Armed, giving a visual indication to any passer-by that the system is equipped with a security system.
MS3001_owner's.qxd 9/10/99 5:27 PM Page 2 Remote Transmitters Remote Transmitter Layout Button 1 LED Button 2 Mode Button Each MS3001 / MS3200 system comes with 2 multifunction Remote Transmitters used to control nearly all of the system’s features. Each time a transmitter button is pressed, the LED will flash to indicate that a transmission is taking place. Button 1 Arms and Disarms the system. This Button also locks and unlocks the doors when the system is in Valet Mode.
MS3001_owner's.
MS3001_owner's.qxd 9/10/99 5:27 PM Page 4 Adding a New Transmitter into the System The MS3001 / MS3200 has the ability to recognize up to 21 individual Remote Transmitters. If the vehicle is used by multiple drivers, each can have their own Remote Transmitter. To add Remote Transmitters: 1. Turn on the ignition. 2. Press and hold the Override switch. • The status LED will turn on red. 3.
MS3001_owner's.qxd 9/10/99 5:27 PM Page 5 Battery Replacement Your Ungo Remote Transmitter uses a 12 volt alkaline battery, which will need to be replaced from time to time. Under normal conditions, the battery should last for up to a year before it needs replacement. When your Remote Transmitter’s battery is in need of replacement, you will notice a decrease in your system’s operating range or a decrease in the brightness of the Transmitter’s LED indicator.
MS3001_owner's.qxd 9/10/99 5:27 PM Page 6 Basic Features Remote Arming When Armed, the system monitors and protects 5 independent areas, or zones, including the ignition switch, doors, hood/trunk, Shock Sensor, and an optional sensor. To Arm the System: 1. Turn off the ignition. 2. Press Button 1. • The siren will chirp once.* • The doors will lock. • The parking lights will flash once. • The LED will turn on red, indicating the ignition, doors, hood and trunk inputs are activated.
MS3001_owner's.qxd 9/10/99 5:27 PM Page 7 Remote Disarming To Disarm the System: Press Button 1. • The siren will chirp twice.* • The doors will unlock. • The parking lights will flash twice. • The dome light will turn on. • The LED will turn off. * The siren chirps during disarming will alert you if the system had been triggered while armed.
MS3001_owner's.qxd 9/10/99 5:27 PM Page 8 Arming Mode Selection Your system can be set in one of the following Arming Modes: • Passive (automatic) Arming with chirp confirmation • Active Arming (by Remote Only) • Passive (automatic) Arming without chirp confirmation To set the Arming Mode: 1. Turn the ignition on. 2. Within 4 seconds, press Buttons 1 and 2 together.
MS3001_owner's.qxd 9/10/99 5:27 PM Page 9 Emergency Override In case your Remote Transmitter becomes inoperable, or it is lost or stolen, you can still enter and drive your car by using the following procedure. Be sure that before you attempt this procedure you have your ignition key ready and that you know the location of the override switch. To override the system: 1. Unlock the door using the key. 2. Enter the vehicle.
MS3001_owner's.qxd 9/10/99 5:27 PM Page 10 Other Features Valet Mode Allows you to temporarily disable the security system when the car is being serviced or turned over to a parking attendant. To turn Valet Mode on or off: 1. Turn on the ignition. 2. Press and hold the override switch. 3. While holding the override switch, turn off the ignition. • The siren will chirp once to indicate you have turned Valet Mode on. • The siren will chirp twice to indicate you have turned Valet Mode off. 4.
MS3001_owner's.qxd 9/10/99 5:27 PM Page 11 Dome Light Control As an option for increased safety and convenience, the system can be set, during the installation, to automatically turn on the dome light when you Disarm the system and when you turn off the ignition. Illuminated Entry. The dome light will turn on for 20 seconds when the system is disarmed (or unlocked in Valet Mode) using the Remote Transmitter. Illuminated Exit.
MS3001_owner's.qxd 9/10/99 5:27 PM Page 12 Auxiliary Function 2 - momentary / latched This Auxiliary Function has two selectable operating modes which can be programmed by your installer to allow custom operation of your vehicle and its accessories. Momentary - the system will provide an output for as long as the Transmitter button is held. Latched - the system will provide an output that turns on when the transmitter button is pressed and turns off when the transmitter button is pressed again.
MS3001_owner's.qxd 9/10/99 5:27 PM Page 13 Reference Chart You can use this chart to quickly identify and interpret your system’s chirp indications and LED flashes.
MS3001_owner's.qxd 9/10/99 5:27 PM Page 14 Technical Data Specifications Main Unit Voltage: 12v, negative ground Current Consumption: <13.5mA Temperature Range: -40oF to +170oF -40oC to +77oC Auxiliary Output Capability: 150mA Internal Relays: 12/28A Transmitter Current Consumption: <.002mA, standby Battery Type: miniature 12v, type 23A FCC ID: MP62VUUUNGO1001 HP92VUUNGO603/03 THIS DEVICE COMPLIES WITH FCC RULES PART 15.
MS3001_owner's.qxd 9/10/99 5:27 PM Page 15 Warranty Information 1. Ungo Security Corporation of Gardena, California ("Ungo Security") warrants this Ungo system to be free from defects in materials and workmanship and to comply with Ungo Security’s applicable printed specifications. 2. Ungo Security systems carry a limited lifetime warranty on the Main unit (system brain) and transmitters.
MS3001_owner's.qxd 9/10/99 5:27 PM Page 16 Ungo Security Corporation A Clarion Company 661 West Redondo Beach Blvd. Gardena, CA 90247 800-Go-Clarion www.clarionmultimedia.com © Ungo Security Corporation, Gardena, CA 97-MS3001-10 Rev.
