VMA633 6.5 INCH WIDE LCD MONITOR VMA633 6.
OWNER’S MANUAL WARNING! THE CLARION VMA633 LCD MONITOR IS DESIGNED FOR NAVIGATION PURPOSE AND REAR SEAT PASSENGER VIEWING ONLY. THIS PRODUCT IS NOT INTENDED FOR VIEWING MOVIES BY THE DRIVER WHILE THE VEHICLE IS IN MOTION. SUCH USE MAY DISTRACT THE DRIVER OR INTERFERE WITH THE DRIVER’S SAFE OPERATION OF THE VEHICLE AND MAY RESULT IN SERIOUS INJURY OR DEATH. SUCH USE MAY ALSO VIOLATE STATE LAW.
VMA633 6.5” TFT LCD Monitor PRECAUTIONS: ● This monitor is intended for use in DC 12V, negative ground vehicles. ● Do not operate the monitor in ways other than described in this guide, doing so may cause damage and void the warranty. ● Be careful not to run down the car’s battery while using a multimedia system with the engine stopped. Doing so may damage the vehicle’s battery or the multimedia system. ● Do not disassemble or modify monitor. Doing so may damage it and void the warranty.
OWNER’S MANUAL DESCRIPTION OF PICTURE ADJUSTMENT: ● Press the PICTURE SELECT button several times, the screen will display the picture control Bar in the following order sequentially. (BLANK)àBRIGHTNESSàCONTRASTàCOLOURàTINTàDIMMERàMEM RESET─ ● Before the display disappears, use the PICTURE SELECT UP (VOLUME UP) button or PICTURE SELECT DOWN (VOLUME DOWN) button, to adjust the picture quality. COLOUR ← ● ● → DOWN UP Press the WIDE/NORMAL button, the screen will display 16:9 or 4:3 picture.
VMA633 6.5” TFT LCD Monitor 1. Look over the vehicle for a monitor location. Each vehicle is different and locations will vary. Make sure the monitor will not interfere with the driver’s safe operation of vehicle. 2. Once a location has been determined, run the 3.5 mm IR extension, Video Composite and power Molex connector into the monitor’s mounting location. 3. Plug main cable into the monitor. 4. Run the IR extension, video, and power cables to their respective destinations. 6.
OWNER’S MANUAL TROUBLESHOOTING: Symptom Cause Solution System does not work Fuse is blown. Replace external fuse with the same value. Check the wire connections and Connect it properly. Check that the brightness is properly adjusted, if not adjust it properly. This may happen if the temperature in the vehicle is below –1°C (30°F) or above 45°C (113°F). Check again when the temperature is between -1°C (30°F) and 45°C (113°F) The screen dark. Power wires are not connected.
