Owner`s manual
Basic
Operations
Opening
and
turning
the
liquid
crystal
panel
•
To
prevent the battery from going dead,
operate
this
unit
with
the
engine running,
if
possible.
• When
the
liquid crystal panel is operat-
ing, be careful
not
to
get
your
hand
or
fin-
ger caught between the panel and main
unit
or
the
instrument panel
of
the car.
• Do
not
move
the
liquid crystal panel by
hand.
Standing
up
the
liquid
crystal
panel
1.
Press the [OPEN] button and the liquid
crystal panel comes out and stand up
automatically.
*While the liquid crystal panel
is
opening or
closing, the LED of
the
[FUNC] button blinks.
Notes:
•
If
the liquid crystal panel stops in the middle
of
its
operation, press the
[OPEN]
button
to
house the
panel
and
press the button again to stand it
up.
The unit enters the same display mode as the
display was turned off the last time.
•
If
the liquid crystal panel stops
at
any
point less
than 70
0
, the electronic beep will sound.
24 VRX745VD
Panel calibration
function
The
liquid crystal panel's maximum angle
of
inclination can be adjusted to match the
installation configuration within the automobile.
• Perform this with the panel
in
its closed position.
1. Deeply push in [FRONT OPEN] button to
unlock the front panel.
2.
Press and hold the [TILT] button for 2
seconds
or
longer, until the electronic beep is
heard.
3.
The beep will sound tWice, and the panel will
rise and the calibration function will begin.
4. After completion
of
the calibration, the panel
will close automatically.
* If the panel does not strike the instrument
panel or other parts of the car during
calibration, the maximum inclination will
be
110°.
* If the panel strikes a car part during calibration
within a range of
70
0
inclination, the maximum
downward inclination will
be
70°.
Adjusting
the angle
of
the
liquid
crystal
panel
The angle
of
the liquid crystal panel can be
adjusted depending on the mounting angle of
the unit
or
light coming into the car.
eTo
adjust
the angle
1.
Every time the
[TILn
button is pressed, the
liquid crystal panel tilts forward
or
backward.
The adjusted angle is stored in memory.
*Adjustment
is
possible within the range 70° to
110°, or within the range set
by
panel
calibration.
* There are 5 adjustable angle available.