Owner's & Installation manual Mode d'emploi et manuel d'installation Manual de instrucciones y de instalaci6n XC141 0 XC AMPLIFIER AMPLIFICATEUR XC AMPLIFICADOR XC
ABOUT THE MANUAL AND WARRANTY This manual describes the basic requirements to install the Clarion XC141 0 amplifier. The installation of this amplifier can be quite complex to install. If you do not posses the necessary knowledge and tools to perform this installation please contact your local Clarion Audio dealer. Keep all instructions and sales receipt for future reference and warranty information. TABLE OF CONTENTS 0 ~ _,
G) Red Wire: to+ 12V Battery terminal. Be sure to properly fuse within 18" of the battery. C?) Black Wire: to chassis ground. Properly mount to clean bare metal of the vehicle. Please keep wire length as short as possible.
INSTALLATION This section suggests Mounting and Wiring Precautions for installing the Clarion XC141 0. If you do not posses the necessary tools and installation experience, do not attempt to install these amplifiers. Instead, contact your local Clarion Audio dealer to perform the installation. MOUNTING PRECAUTIONS Prior to mounting the amplifier, make sure it is safe to mount the amplifier in desired location. Failure to do so can result in serious damage to the vehicle.
WIRING AND APPLICATIONS The Clarion XC141 0 4-channel audio amplifier can be used in a variety of system applications. Here are a few examples to help plan your own installation. Option 1 4-Channel Full Range Stereo System using aftermarket headunit with (low level) RCA's G:>CDCDCDCDCD In this application, the XC141 0 is used as a 4-channel amplifier to drive four full range speakers in stereo. This configuration is for headunits with RCA outputs.
Option 2 4-Channel Full Range stereo system using head unit with (high level) speaker input White/Black FR LT (-) Gray FR RT (+) + 12V Battery (Red) Chassi Ground (Black) Gray/Black FR RT (-) Green RR LT (+) Green/Black RR LT (-) Purple RR RT (+) Purple/Black RR RT (-) go_C: 081 1B lCD
TROUBLESHOOTING Problem No Audio. Amplifier not powering on. (LED turned off) Solution 1. Remote turn-on voltage. Check remote connections at amplifier and source unit. 2. Blown amplifier fuse. Replace with new fuse (same rating). 3. Power wires not connected. Check power and ground wiring at amplifier and at battery. 4. Speaker leads shorted. Check speaker continuity to ground, it should not show common ground. 5. Speakers not connected or are blown.
Clarion Corporation of America All Rights Reserved.
clarion GARANTIE LIMITEE DE 1 AN CLARION Pour le Canada et les Etats-Unis seulement Ce produit Clarion vendu par marchand autorise Clarion est garanti contre tous defauts de materiel et de mise en <:Buvre pour une duree de un (1) an a compter de Ia date de vente initiale quand l'achat ET !'installation ont ete effectues chez un marchand autorise Clarion.
clarion CLARION 1 YEAR LIMITED WARRANTY For USA and Canada only This Clarion product purchased from an authorized Clarion dealer are warranted against all defects in materials and workmanship for a period of one (1) year from the date of original purchase, when purchased from AND installed by an authorized Clarion dealer.
