2.4 GHz Cordless Telephone with Caller ID

24 25
Placing a Call
1. Press the TALK button (TALK button will
illuminate GREEN) and dial the number you
wish to call.
2. To end the call press the TALK button or place
the handset in the base.
Or
1. Press the keys of the numbers needed to dial.
The LCD will display PREDIAL and the
keys pressed.
2. Press the TALK button. Handset will go off-
hook and dial the displayed numbers.
Answering a Call
If the handset is out of the cradle, press the
TALK button.
If the handset is in the cradle with Auto-Connect
Mode ON, lift the handset. The handset will be in
receiver mode.
If the handset is in the cradle with AutoConnect
mode OFF, lift the handset. The handset will be in
standby mode. Press TALK button to receive
the call.
Refer to BOOST Clarity Power and Volume Control
for information on adjusting volume controls on
Page 19.
Last Number Redial
The last number dialed (up to 32 digits) is stored in
the redial memory until another number is dialed.
To use this feature:
1. Press the TALK button.
2. When you hear the dial tone, press the
RD/P button.
3. The phone will automatically dial for you.
Pause Feature
Programming in a pause will cause the phone to wait
four (4) seconds before dialing additional numbers.
This feature may be used when it is necessary to dial
an access code (9, for example) and wait for a sec-
ond dial tone before you can dial an outside number.
Press the RD/P button at the required point during
the memory storage process to program a pause.
Temporary Tone
If you have rotary (pulse) dial service, you can change
from pulse to touch tone (tone) during a call.
1. Make phone call and wait until it
is connected.
2. Press the * key. Keys pressed after this are
sent as tone signals.
3. The phone will automatically reset to rotary
(pulse) service after the call ends.
Lighted Key Pad
The key pad will light for fifteen (15) seconds after
removing the handset from the base. To reactivate
the feature while in standby, press the TALK or the
MEM button. To activate while the phone is in use,
press any key.
Page/Handset Locator
To send a page signal from the base to the handset,
press the PAGE button located on the base of
the telephone. A series of rings will sound from
the handset.
To locate the handset if it is away from the base,
press and hold the PAGE button for approximately
five (5) seconds. A series of rings will sound. Return
the handset to the base or press any
button to cancel the page.
TELEPHONE OPERATIONS TELEPHONE OPERATIONS