User's Manual

17
Press DEL/CH key to move the cursor to the digit 7. Then press other numeric key to
replace 7.
7. Press ENTER after finishing the digits.
8. The display shows ABC with the cursor blinking after the character C.
9. Press any numeric key 2 to 9 to add extra characters.
Or
Press DEL/CH key to move the cursor back to character C. Then press any other
numeric key to change this character.
10. Press ENTER to finish. The modified characters and numbers will replace the
original phone record.
11. The display will show NUMBER STORED.
Adding the EMERGENCY Number
1. Unit must be in standby mode only.
2. Press MODE key twice. The display will show PHONEBOOK for 1 second and
then display the first available record.
3. Press the UP(▲) or DOWN (▼) button to go to the record to be stored to the
EMERGENCY key.
4. Press and hold the EMERGENCY key for 2 seconds.
5. The phone number is copied to the EMERGENCY key. The LCD will display MEM
STORING for one (1) second and the handset will give a success keynote.
Dialing the EMERGENCY Number
1. Unit must be in standby mode only.
2. Press the EMERGENCY key once.
3. The display will show the stored name and number for 5 seconds. Otherwise it will
show -MEMORY EMPTY-.
4. Then the handset goes off-hook and dial out the stored numbers.
Or
5. Press TALK key to make handset goes off-hook.
6. Press the EMERGENCY key once. The display will show the stored name and
number for 1 sec. Then the numbers will be sent out.
Deleting the EMERGENCY Number
1. Unit must be in standby mode.
2. Press the EMERGENCY key once.
3. If this key has been programmed, the display will show the stored number. Otherwise,
it will show MEMORY EMPTY.
4. Press DEL/CH key once to delete this number.
5. The display will flash DELETE?.
6. Press DEL/CH to delete. The handset will give a success keynote and the display will
show MEM DELETED.