User's Manual

The base unit may be mounted on a standard wall plate.

1. Plug one end of the supplied short modular telephone line cord into the TEL jack

located on the back of the base of the phone.

2. Insert the plug of the AC adapter into the jack marked DC 9V 400mA located on

the back of the telephone base.

3. Align the mounting bracket on the back of the base so that the black rubber feet are

towards the bottom of the phone. Insert the bracket’s tabs into the slots and secure the

bracket by sliding it upward.

4. Plug the short modular telephone line cord into the wall plate jack, then align the

mounting bracket’s keyhole slots with the wall plate studs and slide the base of the

phone downward to secure it on the wall.

5. Plug the adapter into a standard AC power (electrical) outlet.

6. Press and lift out the handset holder tab, turn it around so the narrow tab end extends

out and slide back into its slot. This will hold the handset in the cradle when the

phone is wall mounted.

7. Lift the base’s antenna to a vertical position.

8. Set the Tone/Pulse switch located on the end of the base to correct dialing mode.

Please check with your local Phone Company if uncertain of the type of service.

9. Place handset in the cradle to begin initial charging. Remember, you must charge the

phone for at least 12 hours before you use the phone for the first time.

Note: Remember, you must charge the phone for at least 12 hours before you use the

phone for the first time.

BATTERY INSTALLATION

The C4210 uses a 3.6Volt 600mAh NiMH rechargeable 3 cell (AAA Type) battery that is

included with your unit.

Handset Battery Must be Connected Before Beginning Initial Charging

To connect battery, remove battery compartment cover and connect battery pack plug

into the battery connector and replace the battery compartment cover.

Note: The battery in the handset must be fully charged for 12 hours before using the

telephone for the first time.

To Install a New Battery

1. Remove battery cover

2. Install new battery

3. Connect battery pack

4. Replace battery cover

5. Charge for 12 hours before first use

Handset Battery Charging

1. Place the handset in the base. The CHARGE LED on the base will light RED.