Datasheet

2 Installation Clarity
2.5 Clarity Configuration
Note: Clarity is automatically preconfigured for analogue acquisition with no
control modules. However, even the users of analogue acquisition should
review the following chapter to assign custom detector names and signal
units.
l
Start the Clarity station with the icon on the desktop.
l Invoke the System Configuration dialog using the System –
Configuration… command.
Fig 5: System Configuration dialog
l Set the Number of Instruments field .
Note: You can set a larger number of Instruments than you have purchased.
You will not be able to measure on the surplus Instruments (indicated by a
blue icon on the tab), but you may use them e.g. for “offline” preparation
of methods.
l Set the corresponding type of chromatograph (GC/LC/EA/GPC...) for each
instrument using the Instrument Type drop-down list .
l Depending on your hardware configuration, drag and drop the equipment
from the Setup Control Modules list of installed equipment on the left, to
the selected Clarity Instrument x tab on the right. Alternatively, select the
device and press the button .
- 9 -