Datasheet

Getting Started 2 Installation
Note: If necessary, add further equipment to the list on the left using the Add
button in the lower left-hand section of the dialog. The configuration of
particular control modules is described in the corresponding Clarity
Controls manuals.
l The configuration dialog of the corresponding card or equipment is
displayed by double-clicking on its name or icon or pressing the Setup
button :
Fig 6: Dialog for the setting of INT9 converter
l Check and/or change the settings of the detector card (e.g. set the names
of the detectors, signal polarity etc.).
Note: You can change the signal units using this dialog. A more accurate
description can be found in the manual of your A/D converter.
l Press the OK button.
- 10 -