Datasheet

Getting Started 5 Tour through the Clarity station
5.1.2 Single Analysis dialog
Use the Single Analysis button in the Instrument window to open the
Single Analysis dialog.
Fig 11: Single Analysis dialog
l The fields in the Analysis section contain information about the sample.
You may set the values in the fields as shown on the Fig 11 on pg 18., as
typical analysis settings.
l The Sample ID and Sample fields are purely informational, whereas the
data in Amount, Dilution, ISTD Amount and Inj. Volume fields are used
for further calculations.
l Selecting the Calibration Standard and Level fields would mark this
sample as the calibration standard and save the chromatogram into the
CALIB subdirectory.
l The measurement of the sample will be performed according to the actual
modification of the template method opened in the Instrument window.
The Method... button serves to change the parameters of the actual
template method. Click the button to open the Method Setup dialog and
check the setting of the Autostop parameter (Autostop is enabled and Run
Time set to 7.5 minutes). Return to the Single Analysis dialog by pressing
OK button.
l The Chromatogram File Name field is used for entering the file name of
the resulting chromatograms. It is possible to use plain text together with
variables adding the time, date, sample name or other parameters to
create a unique chromatogram name. The resulting name can be seen
just above the field in parentheses.
Note: The complete set of available variables is shown after clicking the field and
selecting the icon.
- 18 -