Datasheet

6 Connecting Autosamplers Clarity
6.4 Auto Sampler - Active Sequence + AS Control + A/D card
When using the optional AS Control (p/n A26) module, all communication
is performed through a separate data cable (usually a serial cable
connected to a COM port).
Caution: Refer to the corresponding Clarity Control manual for wiring specific to
your control module.
The following diagram shows a directly controlled autosampler with
external digital acquisition by an A/D converter (INT9, U-PAD2 and
Colibrick).
In such a case do NOT CONNECT the digital output cable OUT
n
R.
For any controlled autosampler in Clarity, the synchronization via starting
cable (as shown on Fig 23 on pg 37.) is possible. Some autosamplers,
however, do not need the connection of the starting cable, but can send
the start of an injection over communication line. See the appropriate
Clarity Control manual for more details.
Fig 23: Wiring of an autosampler with AS Control module + A/D converter
- 37 -