User manual

Clarity - INT9 A/D converter Using the INT9 card
16
Supply Frequency
Allows to change the Mains Supply Frequency
Suppression. It is used for suppresing the
interference on the specified frequency level.
This setting influences the sampling frequency
as well.
Note: In most parts of Americas, the 60 Hz Mains
frequency is usual, while the rest of the world tends
to use 50 Hz Mains frequency (pre-set as default).
The 50 Hz frequency is common in countries using
230V power supply, while the 60 Hz is connected to
the 117V power supply.
3.2 Method Setup
The Method Setup – Acquisition and Method Setup –
Measurement
dialogs are where the parameters
that depend on the type of analysis (measuring
conditions) are set and so it is expected that
they will be specific for various types of
analysis. This is the reason for them to be a
part of the method.
Caution! Parameters cannot be changed during analysis.
3.2.1 Method Setup - Acquisition
Fig. 10. Method Setup - Acquisition (INT9)