User's Manual

14
Last Number Redial:
The last number dialed (up to 22 digits) is
stored in the redial memory until another
number is dialed.
To use this feature:
1. Press the TALK button
2. When you hear the dial tone, press
the RD/P button
3. The phone will automatically dial
for you
Pause Feature:
Programming in a pause will cause the
phone to wait four (4) seconds before dialing
additional numbers. This feature may be used
when it is necessary to dail an access code
(9, for example) and wait for a second dial
tone before you can dial an outside number.
Press the RD/P button at the required point
during the memory storage process.
Lighted Key Pad
The key pad will light for fifteen (15) seconds
after removing from the base. To reactivate
the feature while in standby, press the TALK
or the MEM button. To activate while the
phone is in use, press any key.
Page / Handset Locator
To send a page signal from the base to the
handset, press the PAGE button located on
the base of the telephone. A series of rings
will sound from the handset.
To locate the handset if it is away from the
base, press and hold the PAGE button for
approximately five (5) seconds. A series of
rings will sound for approximately six (6) sec-
onds. Return the handset to the base or press
the TALK button to cancel the page.
40 Channel Operation
The Clarity 435 cordless telephone automati-
cally searches and selects the clearest of 40
channels when it is being used.
Security Code
The security code prevents your cordless
phone conversations from being accessed
by a phone on a different line. Once the
handset battery is fully charged, the handset
will automatically select the code from
over 65,000 combinations. The code is
changed every time the handset is placed
in the cradle.
If you have trouble with placing or receiving
calls, a lost security code may be the cause
of the problem. When this occurs, the hand-
set can no longer communicate with the
base. Reset by placing the handset on the
base for 5-10 seconds. If that does not work,
unplug the AC adapter from the wall outlet.
Disconnect the handset battery for
5-10 seconds, and then reconnect. Place
handset back on the base and then reinsert
the AC adapter. Place the handset back on
the base and then reinsert the AC adapter.
Operating Yout Telephone
W435Gd_repro 7/6/03 12:41 PM Page 14