Installation guide

www.clarksynthesis.com

Tactile Sound Transducers

DO NOT DROP THE TRANSDUCER- The Transducer can be damaged both internally and externally if 1.

dropped. Damage caused by dropping the Transducer is not covered under the warranty.

DO NOT EXPOSE THE TRANSDUCER TO HIGH DISTORTION LEVELS- Exposing the Transducer to 2.

high levels of distortion may damage the unit. This type of damage is not covered under the warranty. If

the Transducer stops playing, it is likely that the built-in protection circuit has activated. In the event this

happens,turntheamplieroffforapproximately60secondstoallowthecircuittoreset.Turndownthe

volumeontheinputsignalandamplier.Operatethesystematlowervolumelevelstoavoidoverloading

the Transducer.

USE CAUTION WHEN INSTALLING IN FURNITURE- If using this Transducer on a chair, sofa, or 3.

couch,insuretheTransducerisprotectedfromhittingtheoorandfromentanglementwithanyrecliner

components. Severe damage may occur to the wiring. This type of damage is not covered under the

warranty.

CABLEPLACEMENT-UsecautionwhenrunningthecablefromtheampliertotheTransducer.Donot4.

laythecableinhigh-trafcareaswheretrippingorentanglementmayoccur.

DO NOT CARRY THE TRANSDUCER BY THE CABLE- Never carry the Transducer by its cable. This 5.

can damage the strain relief and internal wiring of the Transducer. Damage of this type will not be covered

under the warranty.

DONOTREMOVETHESTRAINRELIEF-Removingoralteringthestrainreliefttingconnectingthewire6.

tothethumpermaypermanentlydamagetheTransducer.Thisttingiscarefullyinstalledatthefactory.

Anyalterationoradjustmentofthisttingwillvoidthewarranty.

AVOID EXCESSIVE HEAT- Exposure to excessive heat will result in internal temperatures that can cause 7.

damage to the components. Damage caused by neglect will not be covered under warranty.

STORAGE- Insure the components are adequately protected when storing or transporting.8.

USEPROPERAMPLIFICATION-InsuretheTransducerisbeingpoweredbyanamplierthatisstableat9.

4 ohms and delivers at least 100 to 150 watts into 4 ohms per Transducer.

EXTERNAL VOLUME CONTROLS- Do not use with external volume controls rated at less than 100 10.

watts.

IMPORTANT PRODUCT INFORMATION