Installation & Assembly

11
SAVE THESE INSTRUCTIONS
This product and its components are ETL listed and IAPMO approved
TWO YEAR LIMITED WARRANTY
All Clarke Products Whirlpools and Bathing Systems are warranted in accordance with the following Limited
Warranty:
Clarke Products Whirlpools and Bathing Systems are warranted against defects in material and workmanship for a
period of two (2) years from the date of the first consumer purchase.
This Warranty shall apply to defective acrylic surfaces which crack, fade or blister, and any defect in whirlpool and
bathing system components.
The Warranty extends to the first consumer purchaser and not to subsequent owners, transferees or users other
than the first purchaser. This warranty does not extend to products previously utilized as display models.
This Warranty shall apply to products installed and used only for personal, family or household purposes and
which are installed and maintained in accordance with Clarke Products Whirlpool and Bathing Systems’
recommended installation and maintenance procedures. This Warranty does not extend to defects or damage
caused, in whole or in part, by any unauthorized or unreasonable use.
No liability shall exist for incidental or consequential damages caused in whole or part by any defects in Clarke
Products Whirlpools and Bathing Systems. No warranty, expressed or implied, including any warranty of
merchantability or fitness for a particular purpose, shall apply after the warranty period described above. Some
states do not allow the exclusion or limitation of incidental or consequential damages or limitations on how long
an implied warranty lasts. The above limitation may not apply to you.
In the event of a defect in material or workmanship of a Clarke Products Whirlpool or Bathing System during the
Warranty period, defective products will be repaired or replaced as Clarke Products, at its sole and absolute
discretion, determines. However, Clarke Products shall not be liable for the expense for removing defective
products or installing replacement products. In certain circumstances, some states do not allow the limitation of
liability for removal, transportation and reinstallation expenses. The above limitation may not apply to you.
Only Clarke Products is authorized to perform its warranty obligation. If you wish to obtain performance of the
Clarke Products warranty obligation you should contact Clarke Products, telephone number
1-800-426-8964. Other information about performance of the Clarke Products Whirlpool and Bathing Systems’
warranty obligation may be obtained at the same address and telephone number.
This Warranty gives you specific legal rights and you may also have other rights, which vary from state to state.