Installation & Assembly

3
SAVE THESE INSTRUCTIONS
Table of Contents
Unpacking the Unit 3
Electrical Requirements 4
Rough-In Measurements 5
Installation Planning & Preparation 6
Installation Instructions 6
Cleaning Instructions 8
Operating Instructions 9
Repair & Trouble-shooting 10
Warranty 11
Tub Cut-out Measurements & Templates 12
ATTENTION INSTALLER
Access should be provided to the whirlpool pump & blower connections and should have
a minimum size of 16” x 14” for installation and future servicing of the bathtub.
Clarke Products may not authorize any service unless clear access is available. Access
from a crawlspace or incomplete access to all equipment may result in warranty claims
being denied.
Unpacking the Unit
1. Inspect the carton.
2. If you note carton damage, take a picture and contact the carrier immediately. Do not install a damaged
tub. Clarke Products is not responsible for damage during transit.
3. Immediately inspect the unit for damage even if there is no visible carton damage and immediately report
any damage to the distributor/manufacturer. Once the unit is installed and there is surface damage
visible, we will assume it was caused by the installer. Installers are responsible for damage that occurs
once the unit is set in place.
4. Inspect the plumbing for any loose fittings.
5. On whirlpool units the unions on the suction and discharge sides of the pump have been color marked to
indicate the alignment that was present at the factory water test. If these are not aligned, retighten and
test for water tightness.
6. Remove all packaging material except for the protective plastic. The protective plastic was put on the tub
to help eliminate abrasions due to handling and should not be removed until you are ready to inspect the
tub just prior to installation.