Installation & Assembly

9
Operating Instructions
1. Fill the bath at least to 3 inches above the jets before activating the pump.
2. The air bath blower and/or whirlpool pump is activated by depressing the control panel buttons. Do not repeatedly
depress the switch in rapid order if you do not see the whirlpool function right away, as it may take a few seconds
before you can see it fully operating. Please see air bath control or Total Massage Control instructions below for
operation and features.
3. If any factory-installed fittings are removed; do not operate the unit. A safety hazard may occur.
4. Do not use bubble bath when you operate the whirlpool pump. This might cause excessive foaming.
5. Bath oils should not be used when you operate the whirlpool pump. If used while soaking, please drain & clean the
tub thoroughly prior to activating the whirlpool system.
6. The use of bath salts is not recommended & doing so will void the consumer’s warranty.
7. Both air and whirlpool systems are plumbed in a way that water will drain from the plumbing easily.
8. The air system on a total massage unit is designed to purge 20 minutes after use, see cleaning on previous page for
details.
9. There are no user serviceable parts located under the tub.

THIS PRODUCT IS DESIGNED FOR RESIDENTIAL USE BY HEALTHY INDIVIDUALS
Children should not be allowed to use these products without adult supervision. Pregnant women and those with heart
conditions or other conditions that limit normal physical activity should consult a doctor before use.
Jet Operation and Adjustment
The jets are easily adjusted by pointing the jet-nozzle in the desired direction. The strength of the water
flow and air induction can be regulated through twisting the jet-nozzle. Turning the nozzle clockwise will
decrease the water flow of that particular jet. If the nozzle is turned counter clockwise then the water
flow will increase up to its maximum flow. Only a 1/4 turn or 90˚ turn is required from the OFF position to
the fully OPEN position.
On/Off Air Switch
Hydromassage tubs that feature whirlpool function only , are equipped with an on-off air switch. Each depression
of the switch will actuate the pump. If off, one depression will turn the pump on, if on, the next depression will
turn it off.
Six Button Control Pad
This control is only found on the Total Massage (combination air & hydro massage) systems.
The whirlpool is controlled by the left three-button controls
1. The jets button (A) switches the pump on or off. Must push this first to operate.
2. The speed button (B) sets the power level of the pump. Holding the button
depressed will cycle the pump power from low to high in a continuous cycle.
When the desired level is reached, remove your finger to maintain setting.
3. The wave button (C) is a three-step wave action button:
a. Position #1 operates the pump at a steady flow.
b. Position #2 operates the pump at a quick wave action.
c. Position #3 operates the pump with a slower wave action.
The air bath is controlled by the right three-button controls
. (Air Massage only, has a 3 button control – same functions as below)
1. The blower button (D) switches the blower on or off. The other features will not operate unless the blower is turned on.
4. The speed button (E) sets the power level of the blower. Holding the button depressed will cycle the blower power from low to
high in a continuous cycle. When the desired level is reached, remove your finger to maintain setting.
2. The wave button (F) is a three-step wave action button. Once activated, the air holes expel air in a slow pulsating flow called wave
action. There are 3 steps or positions for wave strength.
a. Position #1 operates the blower at a steady flow.
b. Position #2 operates the blower at a quick wave action.
c. Position #3 operates the blower at a slower wave action.