Operation Manual

3. Connecting Power

Connect the power cord to a power outlet. Turn on the main power switch (rear panel).

NOTE : AC input condition

• Nominal Voltage Range: 100 - 240 VAC

• Maxi mum Voltage Range: 90 - 264 VAC

• Nominal Frequency: 50 / 60 Hz

• Maxi mum Frequency Range: 47 -63 Hz

NOTE: i means Remote control operation order.

4. Power ON/OFF

[i: Press Power key / Press MENU > Select Standbby/Reset]

There are several ways to turn your ET9000 ON or OFF

• Complete Power Shutdown

There is a Power Switch in the rear panel and once it is ON, you do not need to turn it on or off each time. It takes a longer time to start

(booting) the system if the receiver is turned off by this switch.

• Standby Mode

POWER key is normally used to turn the power of the receiver on or off. If press POWER, it instantly switches the ET90000 off or on. In

this mode, the system is not completely shut down and thus it takes a shorter time to turn it on and off.

• Deep Standby Mode [ i : Menu > Standby/Restart >> Deep Stand by]

Deep Standby is used to reduce the standby power consumption. ET 9000 is designed to be energy efficient and to guarantee the power

consumption to be under 1W in the deep standby mode.