Operation Manual

II. First Time Installation (using Wizard)

When turn on ET9000 for the first time after purchase, an installation wizard will begin step by step.

NOTE : OK key is used for confirmation and turns to the next step. Pressing EXIT key to return to the previous page.

After factory reset the receiver start with “Video Wizard”. Here select your connection. HDMI,SCART or YPbPr.

Note: the connector detection rotates between HDMI - SCART – YPbPr. If Scart is connected , so must wait before TV screen displayed the

video wizard menu ! Probed all 10 seconds !!

HDMI

SCART YPbPr

In the next step choose your Video mode !

SCART or HDMI

Step 1. Language Selection

The ET9000 provides various languages and here you can choose the main language for your ET 9000 . Use UP/DOWN key to scroll up and

down to find the language which needed.

Step 2. Configuring Satellite Connecction

From now on you need to configure the satellite connection. Are 2 options:

• Use installation wizard to setup basic featuress

• Exit wizard