Operation Manual

English

6.1 Getting Started

⊼

Select the item that you want to edit, and set its parameters as desired. <Dish Setting>

- LNB Power : Select among ON/OFF/13V/18V.

- LNB Type : Select among Single/Universal/OCS.

- LNB Freq : Set the frequency of the LNB oscillator.

- 22KHz : When not AUTO, set the signal path from LNB or switch by selecting a control

signal among 0/22KHz.

- DiSEqC switch : Select DiSEqC protocol among OFF/1.0/1.1 as appropriate for your

configuration.

- Committed/Uncommitted : Select the DiSEqC port.

⊽

Select the item that you want to edit and set its parameters as desired. <Motorized

Setting>

- Frequency : If the default TP frequency is not appropriate, you can select another TP

frequency at which to check for signal.

- DiSEqC Motor : Select DiSEqC protocol among OFF/1.2/USALS as appropriate for your

Motor.

3) Antenna Setup

⊹

Press the MENU button to display the main menu.

⊺

Use / and / to move in the menu.

⊻

Press on ‘Dish Setting’. The following window will appear. <Figure 6.1.3>

If you have a motorized dish, press on ‘Motorized Setting’. < Figure 6.1.4>

Note : Enter a 4-Digit password if need arise. The default password is ‘0000’.

VOL

Operation

6.1 Getting Started

After your receiver is powered on, proceed with installation as follows :

1) Menu Language Setting

⊹ Turn on your TV and receiver.

⊺ The pop-up menu for language selection will appear.<Figure 6.1.1>

Select one language and press to proceed.

2) Country Setting

⊹ Select a country and press the button on.