Operator`s manual

EN
ENGLISH
-10- Clarke
®
American Sanders Operator's Manual (EN) - EZ Sand
Sanding Cuts and Sandpaper
Initial Cut
The purpose of the initial cut is to remove old fi nish and gross imperfections on the fl oor surface. Use a course (20-36 grit) grain
abrasive.
Final Cuts
The purpose of a fi nishing cut is to remove the scratches produced during the initial cut. Use a fi ne (60-80 grit) grain abrasive.
If the surface remains rough after a fi nishing cut, it may be necessary to use an even fi ner grain of abrasive (80-100grit). Care
should be taken in selecting the grit size of the abrasive. A very fi ne grain will close the pores on a wood fl oor making admission of
a stain diffi cult.
If glazing or burning should occur the abrasive has dulled and must be replaced.
Grain Use Standard
Grade
Part#/Qty.
For removing gross imperfections and restoring
20 grit evenness to old fl ooring. To remove buildup of 54082A
paints and varnishes
For the fi rst sanding of new fl ooring (maple, oak).
36 grit For removing minor imperfections and fi nishes 54081A
from old fl ooring.
60 grit For clean-up from initial cut 36 grit. 54080A
80 grit For fi nal sanding of certain hardwoods. For 54079A
clean-up of cuts (60 grit).
100 grit For fi nal sanding of certain hardwoods and
conifers where a smooth surface is desired. 54078A
120 grit For fi nal sanding of certain hardwoods and
conifers where a smooth surface is desired. 53886A
For leveling after initial fi nish coat.