Operator`s manual

EN
ENGLISH
Clarke
®
American Sanders Operator's Manual (EN) - EZ Sand - 9 -
Troubleshooting
Problem Cause Action
Motor will not start. No power. Check power supply and connection
Interlock not depressed. Depress Interlock before activating
control lever.
Defective switch/ Bad connection Contact an authorized American
Sanders Technology Dealer.
Motor fails to start / runs Low voltage from excessive length Use a 14 Ga extension cord, not to
sluggish. or undersized extension cord. exceed 50’ length.
Defective start switch. Contact an authorized American
Sanders Technology Dealer.
Defective motor low voltage Contact an authorized American
Sanders Technology Dealer.
Fuse / Circuit Breaker repeatedly Low voltage. Eliminate extension cord.
trips. Locate power source closer to
work site. Have voltage checked by
a qualifed electrician.
Bad connection. Contact an authorized American
Sanders Technology Dealer.
Defective motor. Contact an authorized American
Sanders Technology Dealer.
Handle feels loosely connected The latches have loosened up. To tighten latches, loosen the lock
to base machine. nut, screw in the latch hook and
then tighten the lock nut.