Specifications

POTENTIAL PROBLEM DURING USE

Insufficient

penetration

1. Cutting speed too high.

2. Torch is tilted.

3. Workpiece is too thick.

4. Cutting current is too low.

5. Torch parts are worn out.

Interuption of the

utting arc

1. Cutting speed too slow;

2. Excessive distance between torch and workpiece;

3. AC line too low - reduce output current;

4. Torch parts are worn out;

5. Non-genuine Manufacturer's parts;

6. Work cable is disconnected;

Excessive scoria

settlement

1. Too low cutting speed (bottom dross);

2. Too high cutting speed (top dross);

3. Excessive distance between torch and workpiece;

4. Cutting current too low;

5. Torch parts are worn out;

6. Non-genuine Manufacturer's parts;

Tilted cutting 1. Torch position not correct;

2. Asymmetric wear of nozzle hol

e and/or wrong assemblage

of the torch parts;

Excessive wear of

he nozzle and

electrodes

1. Air pressure too low;

2. Exceeding system capability (material too thick);

3. Contaminated air (hum

idity-oil);

4. Excessive pilot arc arc ignitions in the air;

5. Improperly assembled torch;

6. torch tip contacting workpiece;

7. damaged or loose torch head components;

8. non-genuine Manufacturer's parts.