© 0700 6” Bench Grinder with Sanding Belt Model CBG6SB Part Number 6500032 Operating & Maintenance Instructions
Spare Parts List No. Description Parts and Service For Spare Parts and Servicing, please contact your local dealer, or Clarke International on one of the following Numbers: Parts and Service Tel: 0208 988 7400 Parts and Service Fax: 0208 558 3622 or email as follows: Parts: Parts@clarkeinternational.com Service: Service@clarkeinternational.com Part No. No. Description Part No.
Spare Parts Diagram Contents Guarantee ...................................................................................................... 3 Features and Use ........................................................................................... 3 General Safety Precautions : For Power Tools ............................................. 4 Safety Precautions : For Bench Grinders ..................................................... 5 Electrical Connections ............................................
General Safety Precautions : For Power Tools WARNING! Read these safety instructions before using the equipment. Keep Children away when using Power Tools. Eye Protection manufactured to the current European Safety Standards should be worn when using Power Tools. Specifications Model No ................................................................. CBG 6SB Part No ..................................................................... 6500032 Overall Dimensions ............................................
Safety Precautions : For Bench Grinders Troubleshooting : Problem The Motor does not start when switched on. Unusual vibration when the machine is switched on. Excessive noise when the machine is switched on. Possible Cause 1. The power supply is not properly connected. 1. Check and rectify 2. The Fuse has blown. 2. Renew Fuse 3. The motor is burnt out. 3. Contact Clarke Service 1. The grinding wheel is not properly fitted 1. Refit the grinding wheel (as described in Maintenance) 2.
(f) Electrical Connections Changing the Sanding Belt Top Roller Securing Knob WARNING! This Appliance must be Earthed fig (9) Tracking Adjustment Screw Connect the mains lead to a standard 230V (50Hz) electrical supply through an approved 13 Amp BS1363 plug, or a suitably fused isolator switch fig (9a) Cover Belt Tensioning Nut IMPORTANT : The wires in the mains lead are coloured in accordance with the following code: Green & Yellow ........... Earth Blue ..............................
(d) Changing the Grinding Wheel Figure (1) Overview 1 To renew or change the grinding wheel, follow the steps given below. 1. Switch off and unplug from mains power supply. Remove the grinding wheel covers by unscrewing the nuts securing the three retaining screws, and the sanding belt cover by unscrewing its three retaining screws. 2. Remove the spark arrester bracket and eye shield by unscrewing the single mounting screw.
Using the Machine (a) Maintenance WARNING ! Ensure the grinder is disconnected from the mains before carrying out any maintenance. Due to the reduction in diameter of the grinding wheel caused by wear, it is necessary to check and adjust the clearance gap of the spark arrester and tool rest to maintain suitable clearance from the wheel. It is recommended that a gap of 1.6 mm is maintained.
