User guide

7
Parts & Service: 020 8988 7400 / E-mail: [e-mail] or [e-mail]
1. Lay the stove down on a soft
surface such as the packing
materials from the crate.
2. Attach the legs using the studs,
nuts and washers supplied as
shown in Fig 1. Tighten the studs
using the spanner.
3. Sit the stove upright and attach
the flue adaptor as shown in Fig 2
using the screws supplied. Ensure
the fireproof gasket is correctly
seated in the base of the flue
adaptor.
4. Install the blanking plate in the
rear of the stove when the normal
flue exit is required.
• If the rear mounting flue
configuration is to be used, the blanking plate will be fitted to the top of
the stove and the flue connector to the rear panel.
5. Check that the firebricks and grate have not been dislodged during transit.
6. Set the ashpan in position as
shown in Fig 3. An ashpan handle
is supplied for when the stove is in
use.
7. Place stove in the desired
location as shown in POSITIONING
AND INSTALLATION. Take care not
to damage the floor surface.
8. Adjust the stove levelling bolts
shown in Fig 1 until the stove is
level and evenly supported, and does not rock. Take care not to damage
the floor surface.