IVIE Enterprises www.ivie-ent.
SERVICE AND MAINTENANCE WARNING: Maintenance and repairs must be done by authorized personnel only. Keep Adjustments according to specifications. WARNING: To prevent injury always stop the engine or motor before doing any maintenance or repairs to this machine. Separate the connectors between the machine and batteries. Disconnect the wire from the spark plug. How To Check the Engine 1. Check oil level regularly. Change oil after using first two tanks of gasoline.
Drive Belts WARNING: To prevent injury always stop the engine or motor before doing any maintenance or repairs to this machine. The drive belts are automatically tensioned by a springloaded idler wheel. (See Fig. 9) 1. 2. 3. 4. 5. Remove the idler pulley tension spring. Slip the belt off the pulley. Install a new belt. Assemble idler tension spring. Align pulleys and belts if necessary. Main Broom Adjustment The main broom should be periodically readjusted as needed to compensate for wear.
Installation of New Main Brush (cont) Remove the three screws and washers and the bristle strip retained by them. Install the new strip and assemble the retaining screws and washers. Be sure to install the "V" of each strip in the same relation to the core as its companion strips. (See Fig. 11, page 11) CAUTION: The strips must be carefully centered on the core before they are firmly locked into position.
Capacitor Test If a commercial capacitor checker is not available, the following test may be made: 1. Briefly short the capacitor terminals together with a screwdriver. 2. Disconnect a wire from either capacitor terminal. 3. Adjust an ohmmeter to a high value such as RX10K or RX1 Meg. 4. Connect the ohmmeter leads to the capacitor terminals. 5. A good capacitor will cause the indicator to move quickly to zero ohms, then slowly return to infinite ohms.
CLARKE TECHNOLOGY Model SPS-28 Main Frame, Brush Assembly and Drive System Drawing 1/99 9293 4 5 6 4 49 21 19 2 14 3 1 22 10 11 12 7 8 27 42 29 69 31 22 23 24 2 33 32 15 34 25 26 1211 13 10 46 27 28 28 29 30 59 49 13 72 20 62 14 10 22 37 38 39 36 40 47 41 49 48 80 85 89 66 94 6869 31 24 3 74 95 42 78 28 42 58 49 51 70 26 2573 42 52 34 25 60 4 6 5 82 4 49 84 82 65 83 53 49 69 62 33 32 82 87 45 49 44 32 81 18 20 43 49 50 18 22 35 27 33 16 17 49 71
CLARKE TECHNOLOGY Model SPS-28 Main Frame, Brush Assembly and Drive System Parts Lists 1/99 Ref # 1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 Part No.
CLARKE TECHNOLOGY Model SPS-28 Engine, Dust Control & Handle Assembly Drawing 4/99 62 34 66 46 63 64 47 48 71 23 15 65 11 67 70 59 26 50 22 49 69 52 49 26 26 60 49 26 24 73 8 61 53 72 11 74 51 58 56 11 12 3 4 5 96 6 11 10 91 83 93 92 9 25 17 55 75 11 78 8 34 7 34 57 82 90 13 95 1416 26 40 79 18 19 20 8321 80 81 68 43 77 45 44 1 28 29 76 78 8 8 94 53 54 26 30 32 31 85 83 84 33 43 34 88 87 2711 35 86 42 89 26 36 37 38 37 31 39 1141 34 Page 18 34
CLARKE TECHNOLOGY Model SPS-28 Engine, Dust Control & Handle Assembly 4/99 Ref # 1 2u 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 Part No.
Page 20 34 49 TOP 27 BOTTOM 28 26 52 5 7 50 CLARKE TECHNOLOGY Model SPS-28 Space Sweeper Operator's Manual 32 33 33 32 29 35 36 30 53 55 5758 61 54 37 52 17 16 19 6 47 24 2 20 6 31 62 39 40 15 4 20 42 41 25 14 OPTIONAL 43 SIDE BROOM ASSEMBLY 22 7 38 64 3 65 11 OR 63 43 14 48 44 45 46 12 64 65 8 13 3 10 66 13 IVIE Enterprises www.ivie-ent.
CLARKE TECHNOLOGY Model SPS-28 Hopper and Optional Sidebroom Assembly Parts List 1/99 Ref # 1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 Part No. 60075A 798529 930090 725197 793921 798203 962568 797820 962385 962677 791220 962803 889706 920196 790823 798523 797220 793426 797222 962073 797421 797501 920160 920110 920200 26 27 28 29 30 31 32 33 794201 419702 960953 796902 796903 960970 902659 167308 Description Hopper Support, Hopper Top Rivet, 5/32 Dia.
CLARKE TECHNOLOGY Model SPS-28 Battery Powered Model Drawing 1/99 1 2 23 53 25 51 54 22 50 24 4 20 5 27 19 21 36 6 28 26 30 29 31 32 34 33 19 11 12 38 49 43 3 48 14 Page 22 41 47 36 37 36 37 13 11 12 16 17 18 42 3639 7 14 40 35 24 11 12 16 55 44 45 41 46 26 30 30 52 23 CLARKE TECHNOLOGY Model SPS-28 Space Sweeper Operator's Manual
CLARKE TECHNOLOGY Model SPS-28 Battery Powered Model Drawing 1/99 Ref # Part No.
CLARKE TECHNOLOGY Model SPS-28 Wiring Diagram & Electrical Schematic 1/99 Page 24 CLARKE TECHNOLOGY Model SPS-28 Space Sweeper Operator's Manual
CLARKE TECHNOLOGY Model SPS-28 Wiring Diagram 1/99 Ref # Part No. 1 871376 871377 2 41207A 3 911470 4 951006 5 855607 6 911440 7 980614 8 950807 9 950806 10 950805 11 951004 12 794720 13 795220 14 911438 15 950813 16 842406 Description Battery, 95 amp Hr. (Wet) Battery, 95 amp Hr. (Dry) Cable, Battery Connector Wire Assembly Hour Meter (Optional) Circuit Breaker Washer, ΒΌ External Tooth Wire Assembly, #10 White Wire Assembly, #10 White Wire Assembly, Teminal Board - Mtr.