Operator`s manual

Page -6- CLARKE TECHNOLOGY Operator's Manual -Vision 17E 230V
230 VOLT MACHINES
INSTRUCTIONS FOR CONNECTION
TO THE POWER SUPPLY
AND THE ELECTRICAL GROUND
CAUTION: To avoid damage to the machine oper-
ate only on AC frequency and electri-
cal voltage shown on the nameplate.
Make sure you have the correct fre-
quency and voltage before connecting
the power cord to an outlet.
This product must be grounded. If it should malfunc-
tion or breakdown, grounding provides a path of least
resistance for electric current to reduce the risk of
electric shock. This product is equipped with a cord
having an equipment-grounding conductor and
grounding plug. The plug must be inserted into an
appropriate outlet that is properly installed and
grounded in accordance with all local codes and
ordinances.
WARNING: Improper connection of the equip-
ment-grounding conductor can result
in a risk of electric shock. Check
with a qualified electrician or service
person if you are in doubt as to
whether the outlet is properly
grounded. Do not modify the plug
provided with the product - if it will
not fit the outlet, have a proper out-
let installed by a qualified electrician.
This product is for use on a nominal 230 volt circuit
and has a grounding attachment plug that looks like
the plug illustrated in Fig. 1. Make sure that the
product is connected to an outlet having the same
configuration as the plug. No adaptor should be used
with this product.
This machine must be connected to the electrical
ground to protect the operator from electrical shock.
The machine has a power cord with two main conduc-
tors and one earthing conductor. Connect the plug to
the receptacle. The green and yellow conductor in the
cord is the ground wire. Never connect this wire to any
terminal other than the ground terminal.
Figure 1
Pin Earthing Contact
European Plug
Side Earthing Contact
WARNING: To avoid electrical shock always use
this machine with an AC three-con-
ductor electrical system connected
to the electrical ground. Replace any
worn, cut or damaged cords. Re-
place any damaged plugs, recep-
tacles, or connector bodies. Do not
move the machine over an electrical
cord. Always lift the cord over the
machine.
EXTENSION CORDS
Use only an approved extension cord with two main
conductors and one earthing conductor. The
machine has a power cord with wire size 1.5mm
2
.
WARNING: To avoid motor burnout, if you use an
extension cord, use an extension
cord with minimum wire size 1.5mm
2
.
Do not use an extension cord longer
then 15 meters. Do not join two ex-
tension cords.
WARNING: To avoid electrical shock, do not cut,
remove or break the ground terminal.
Do not try to fit a three-terminal plug
into a receptacle or connector body
that does not fit the plug. If the re-
ceptacle or connector body does not
fit the plug, see your authorized
Clarke dealer to get an authorized per-
son to make the connection.
Grounding Instructions - 230 Volt