Operator`s manual

Page -10- CLARKE TECHNOLOGY Operator's Manual -Vision 17B/BT
How to Install the Squeegee
To install the squeegee, follow this procedure:
1. Attach the squeegee cable to the squeegee lift
arm (Figure 15) and squeegee bracket (Figure
16).
2. Raise the squeegee lift arm.
3. Place the squeegee onto the squeegee bracket.
4. Push the hair pin through the holes on the
squeegee bracket.
5. Attach the squeegee hose to the hose connec-
tion on top of squeegee. See figure 17.
CAUTION: Leaving the squeegee "DOWN"
when the machine is not in use
can damage the squeegee blades.
Always leave the squeegee in the
"UP" position when not in use.
MACHINE CONTROLS and FEATURES (cont'd)
Key Switch. See Figure 14.
The battery traverse model has a key switch located on
the back side of the control panel. The key switch must
be turned to the on position (I) to activate the traverse.
The key may be removed for security purposes from
the off position (O).
The Parking Brake.
The brake prevents the movement of the machine. The
brake pedal is at the back of the machine in the lower
left corner. To activate the brake, push the pedal down.
Lift the pedal to release the brake.
HOW TO PREPARE THE MACHINE FOR OPERATION
Figure 14
Figure 15
Figure 16
Figure 17