Operator`s manual

CLARKE TECHNOLOGY Operator's Manual - Vision 17B/BT Page -11-
HOW TO PREPARE THE MACHINE FOR OPERATION
How to Install the Squeegee Connection
The proper method for assembling the squeegee
connection is as follows::
1. Unscrew the nut completely.
2. Slide the nut and gasket onto the tube.
(Figure 1a)
3. Slide the elbow onto the tube and make sure
the gasket is secured into the elbow.
(Figure 2a)
4. As you hold the elbow tight onto the tube,
tighten the nut over the gasket and the elbow.
(Figure 3a)
How to Install or Remove a Brush or
Pad Driver
To install or remove a brush or a pad driver, follow this
procedure:
NOTE: The brush may spin off the machine if
the brush switch is turned ON or OFF while the
brush is in the raised position.
1. If machine is an electric model disconnect the
power supply.
2. Put the squeegee down to the floor by pulling
the squeegee handle to the right and down.
3. Remove the cotter pin from the squeegee
bracket and remove the squeegee. See Figure
17.
4. Slide the squeegee bracket either right or left
all the way under the machine skirt. See
Figure 16.
5. While lifting the machine up with the machine
lift handle (a), lower the support leg and
position like a kickstand (b). See Figure18
6. To install the brush or pad driver, align the lugs
on the locking plate of the pad driver or brush
with the adapter plate.
7. Turn the brush or pad driver clockwise to lock it
in position.
Figure 1a
Figure 2a
Figure 3a
Figure 18
TUBE
NUT
GASKET
ELBOW
GASKET
NUT