Operator`s manual

Page -16- Clarke Technology Operator's Manual -Vision 21i - Vision V
WARNING: Water solutions or cleaning materi-
als used with this type of machine
can leave wet areas on the floor
surface. These areas can cause a
dangerous condition for the opera-
tor or other persons. Always put
CAUTION signs near the area you
are cleaning.
WARNING: Machines can ignite flammable ma-
terials and vapors. Do not use with
or near flammables such as gaso-
line, grain dust, solvents and
thinners. Only use a cleaning con-
centrate recommended by the
chemical manufacturer.
NOTE: Put the machine in the "LO" traverse speed. Use
the machine in an area that has no furniture and objects
until you can do the following:
1. Move the machine in a straight direction, forward and
backward.
2. Stop the machine safely.
3. Move the machine in a straight direction after you turn
the machine.
To move the machine, follow this procedure:
1. Release the parking brake.
2. Turn the key switch “ON” position.
3. Put the brush switch in the "UP" position.
4. Raise the squeegee.
5. To go forward, push the control handles toward the
machine. See figure #16.
6. To stop the machine, put the handles in the center
position.
7. To go backward, pull the handles away from the
machine. See figure #17.
8. To turn the machine, push the rear of the machine to
the side.
9. When you stop the machine, turn the key switch
"OFF".
Figure # 16
Figure #17
HOW TO OPERATE THE MACHINE (cont.)