Operator`s manual

Page -22- Clarke Technology Operator's Manual -Vision 21i - Vision V
These Maintenance Procedures Must Be Done Every
Week:
WARNING: Maintenance and repairs must be
done by authorized personnel only.
Always empty the solution tank and
the recovery tank before doing any
maintenance. Keep all fasteners
tight.
WARNING: Always wear eye protection and pro-
tective clothing when working near
batteries. Do not put tools or other
metal objects across the battery ter-
minals or the tops of the batteries.
CAUTION: To prevent damage to the machine,
and discharge across the tops of the
batteries, do not fill the batteries
above the bottom of the tube in each
cell. Wipe any acid from the machine
or the tops of the batteries. Do not add
acid to battery after installation.
NOTE: Always engage the parking brake before serv-
icing the machine.
WARNING: Always wear eye protection and protec-
tive clothing when working near bat-
teries. NO SMOKING!
1. To inspect batteries, tip up recovery tank and pull out
the stop pin to hold the tank up. See Figure #23
2. Disconnect the batteries. Use a cloth and a solution
of ammonia or bicarbonate of soda to wipe the top of
the batteries. Clean the battery terminals. Reconnect
the batteries.
3. Check the hoses for leaks, obstructions and other
damages.
4. Check and clean the filter screen in the solution hose.
To clean the screen, follow this procedure:
a. Turn the connector to the left.
b. Remove and clean the filter screen.
c. Install the filter screen in the hose. Turn the
connector to the right to connect he hose.
5. Use a grease gun to lubricate the drive wheel and the
casters. See figure #24.
6. Apply a thin lubricant to the drive chain.
MAINTENANCE
Figure #23
Figure #24