BATTERY/BOOSTER CHARGER Model No: BC100N Part No: 6210101 OPERATING & MAINTENANCE INSTRUCTIONS 0906
Specifications Max Charge ......................................................... 15Amps Duty Cycle ............................................................ 100% 10A Arith. Max Boost ............................................................. 100Amps Boost/Charge ....................................................... 12Volts (D.C.) Thermal Overload Protection ............................. YES Dimensions (Lxwxh) mm ...................................... 175x130x239 Weight . .........................
Thank you for purchasing this CLARKE Battery Charger. Th1s units is designed for charging 12 Volt, lead acid battery and for providing a boost start in the event of a flat battery Before attempting to operate the charger, please read this instruction manual thoroughly, and follow all directions carefully. By doing so you will ensure the safety of yourself, and others around you, and at the same time, you should look forward to the unit giving long and trouble free service.
IMPORTANT: SAFETY PRECAUTIONS PLEASE READ BEFORE USING THIS UNIT 1. WARNING: Some electronic equipment can be damaged by boost charging or use of start facility. Check your vehicle handbook before using your Start ’N’ Charge. If in doubt consult the vehicle manufacturer. Nevertheless, you should not operate this equipment unless you are fully conversant with vehicle electrical systems, and battery charging techniques. 2.
. ELECTRICAL CONNECTIONS WARNING! THIS APPLIANCE IS DOUBLE INSULATED Connect the mains lead to a 230 volt (50Hz) domestic electrical supply via a standard 13 amp BS 1363 plug fitted with a 13 amp fuse, or a suitably fused isolator switch.
Fig.1 Procedure For Engine Starting. 1. Check that the CHARGE/BOOST START switch (2) is in the OFF (O) position. 2. Connect the appropriate output conductor to the unearthed battery terminal. 3. Connect the other output conductor to the chassis, or engine bolt, away from the battery and fuel line 4. Switch on the mains supply. 5.
Procedure For Normal Charging (refer to Fig.1). 1. Before charging or boosting ensure the battery terminals are clean and that the cells are filled with electrolyte to the correct level by adding distilled water where necessary. 2. Where appropriate we recommend that the positive (-1-) lead (on the vehicle) to the battery is disconnected prior to charging. 3. Check that the CHARGE/BOOST START switch (2) is in the OFF (0) position. 4.
Wiring Diagram 8
Parts Diagram No. Description Qty Part No: 01 Black Housing For Battery Chargers ............................... . 1 EM21690085 02 Welding Current Switch 16A 250V ................................. . 1 EM22200038 03 Thermic Switch 20A ......................................................... . 1 EM22210018 04 Switch 16A 250V ............................................................... . 1 EM22200041 05 Rectifier 2 Diodes ............................................................. .
CLARKE Battery/Booster Chargers Other Battery Booster/Chargers in the comprehensive Clarke range include Model No: Max Charge Max Boost Boost Charge Thermal Dimensions Weight Part No: Amps Amps Volts Overload LxWxH - mm kg BC140 15 140 12 yes 260x260x250 10.0 6210150 BC160 20 160 12 yes 260x260x250 12.5 6210000 BC180 20 180 12/24 yes 260x300x770 16.0 6210180 BC200 30 200 12/24 yes 260x300x770 21.0 6220000 BC250 30 250 12/24 yes 320x490x730 28.
