Specifications

Before Using the Grinder

Fit the Handle : Screw the handle (4) into the appropriate position in the grinder head

as required.

1 Safety ON/OFF Switch

2 Spindle Lock Button

3 Moveable Blade Guard

4 Handle

5 Abrasive Disk

6 Body

Figure (1) Overview

- 7 -

Adjust the Guard : The guard (3) needs

to be adjusted to give maximum

protection from sparks and debris

produced when grinding. This must be

done before mounting the wheel/disk.

Slacken the four screws, arrowed in Fig

1a by half a turn only, sufficiently for the

guard to be rotated to its desired

position. When satisfied, tighten all four

screws securely.

Mount the Grinding Wheel / Cutting Disc

: See page 8 for details

Connecting to the Power Supply : Connect to the power supply using a Residual

Current Device. Do not use in wet or damp conditions.

WARNING ! Ensure that the power supply is disconnected before adjusting the guard

or mounting the handle.

Figure.1a Adjusting the Guard