DIE GRINDER MODEL NO: CAT 89 PART No: 3110845 OPERATION & MAINTENANCE INSTRUCTIONS 0902
CONTENTS Specifications .......................................................................... 4 Guarantee ............................................................................... 5 Safety Precautions .................................................................. 6 Operating Instructions ........................................................... 7 Maintenance .......................................................................... 7 Parts List & Diagram ...................................
Fig.1 SPECIFICATIONS Model : .......................................................................... CAT 89 Part No : ....................................................................... 3110845 Free Speed ........................................................... 20,000 RPM Collet Capacity ..................................................... 1/8” - 1/4” Maximum Air Consumption : ....................................... 8 CFM Maximum Air Pressure : .................................. 90 PSI (6.
Please read these instructions carefully before operating the tool Thank you for purchasing this CLARKE Air Die Grinder Before using the device, please read this manual thoroughly and carefully follow all instructions given. This is for your own safety and that of others around you, and is also to helpyou achieve long and trouble free service from your new tool. CLARKE GUARANTEE This CLARKE product is guaranteed against faulty manufacture for a period of 12 months from the date of purchase.
SAFETY PRECAUTIONS AIR SUPPLY Tools of this type, operate on a wide range of air pressures. It is recommended that air pressure to this tool does not exceed 90 PSI (6.1bar), at the tool when running. Higher When operating this tool, ALWAYS wear: pressure and unclean air, will shorten the tools’ life because of faster wear, and could be a a. approved impact resistant SAFETY safety hazard. GOGGLES.
OPERATING INSTRUCTIONS Before starting work drain any water from the air tank and blow condensation from the air line. Drain compressor more frequently in hot humid weather. 1. Ensure Grinder is disconnected from the air supply. MAINTENANCE 2. Loosen collet nut, and insert appropriate Daily before use. grinding stone. Tighten collet using 1. Drain water from air tank, air line and spanners supplied. compressor. 3. Depress throttle lever and wait until motor 2.
PARTS DIAGRAM PARTS & SERVICE TEL: 020 8988 7400 or e-mail as follows: PARTS: Parts@clarkeinternational.com SERVICE: Service@clarkeinternational.
PARTS LIST Index No Part No Description Qty I KL89001 Double Ended Spanner 1 2 KL89002 Double Ended Spanner 1 3 KL89003 Collet Nut 1 4 KL89004 Collet 1 5 KL89005 Housing Cap 1 6 KL89006 Retainer 1 7 KL89007 Spindle 1 9 KL89009 Ball Bearing 1 10 KL89010 Front End Plate 1 11 KL89011 Ball 3 12 KL89012 Cylinder 1 13 KL89013 ‘O’ Ring 1 14 KL89014 Rotor 1 15 KL89015 Rotor Blade 4 16 KL89016 Rear Plate 1 17 KL89017 Ball Bearing 1 18 KL89018 Moto
HAND-ARM VIBRATION Employers are advised to refer to the HSE publication “Guide for Employers”. All hand held power tools vibrate to some extent, and this vibration is transmitted to the operator via the handle, or hand used to steady the tool. Vibration from about 2 to 1500 hertz is potentially damaging and is most hazardous in the range from about 5 to 20 hertz.
