Specifications

12
Parts & Service: 020 8988 7400 / E-mail: [e-mail] or [e-mail]
MAINTENANCE
DAILY
• Drain any water from the air tank, airline, and compressor.
• Pour a few drops of CLARKE air line oil, into the air inlet. This should be
carried out regardless of whether or not an air line lubricator is used. If an
airline lubricator is not used, this procedure should be repeated after
every two to three hours of use.
WEEKLY
• Check the air inlet screen filter
and clean if necessary. It may
be necessary to unscrew the air
inlet connector to achieve this.
CLEANING
• Keep the body of the air drill
clean and free from debris, grit
or gum deposits in the tool may
reduce efficiency.
• After extensive use, remove the inlet screen filter and flush out the
mechanism with gum solvent oil or an equal mixture of SAE No10 oil and
paraffin. Allow to dry before use.
SERVICE AND REPAIR
• Major servicing and repairs should be carried out by a qualified service
technician.
PERFORMANCE
• Please note that factors outside the tool may effect its operation and
efficiency such as reduced compressor output, excessive drain on the
airline, moisture or restrictions in the line, or the use of connectors of
improper size or poor condition which will reduce air supply.
• **Clarke air line oil (Part no. 3050825) is available from your CLARKE
dealer.
WARNING: MAKE SURE THAT THE AIR DRILL IS DISCONNECTED FROM THE
AIR SUPPLY BEFORE STARTING ANY CLEANING, OR MAINTENANCE
PROCEDURES.