Operating instructions

9
Parts & Service: 020 8988 7400 / E-mail: [e-mail] or [e-mail]
FITTING THE GRINDING STONE INTO THE DIE GRINDER
IMPORTANT: Never use chipped or cracked grindstones. Never use
grindstones not rated to operate at a speed equal to, or greater than, the
full operating speed of the air tool.
1. Slip the shank of the chosen stone
into the collet and tighten the
screw cap finger tight.
2. Place the smaller of the two
wrenches over the collet seat to
stop the tool from rotating.
3. Use the larger wrench to fully
tighten the collet and grip the
stone in position as shown.
SETTING THE SPEED
1. Adjust the tool speed by setting
the air regulator on top of the tool
body using a suitable screwdriver.
OPERATING THE TOOL
1. Use your thumb to slide the
throttle locking lever forward while
squeezing the trigger against the
body of the tool.
2. Do not use excess pressure on the
grinding stone as this will shorten
its life.
3. Release the trigger to stop the
tool.
• The tool will continue to rotate
very briefly after the trigger has been released.
4. Always ensure the tool has stopped before putting it down.