Specifications

11
Parts & Service: 020 8988 7400 / E-mail: [e-mail] or [e-mail]
MAINTENANCE
Keep the machine clean by wiping off dust with a clean cloth, and
occasionally blowing the grinder through with air. Always wear protective
goggles when blowing through with compressed air.
CHANGING THE GRINDING WHEELS
1. Remove the three screws from the
wheel cover and then remove the
cover.
2. Hold the other wheel by hand,
and remove the nut and outer
flange.
3. Slide off the old grinding wheel.
• Use only grinding wheels
recommended by the manufacturer which have a marked speed
equal to or greater than the speed marked on the nameplate of the
tool and have maximum dimensions of 150 mm diameter, 20 mm thick
with a bore size of 12.7 mm.
• Inspect the wheel for cracks, chips or any other visible damage,
damaged abrasive products must be destroyed and discarded
NOTE: The left hand grinding wheel locking nut has a left handed thread.
4. Replace the outer flange.
• Make sure both wheel flanges
are placed with the concave
sides towards the wheel.
5. Replace the nut securely.
• Do not overtighten as this may
damage the grinding wheel.
6. Re-assemble the guards fully prior
to carrying out testing.
• Each time after mounting, the wheel should be test run for a
reasonable time (approximately 1 minute).
WARNING: DISCONNECT THE GRINDER FROM THE MAINS SUPPLY BEFORE
FITTING REPLACEMENT WHEELS, CLEANING OR ADJUSTMENT.
CBG6250 Bench Grinder.fm Page 11 Wednesday, August 31, 2011 11:06 AM