Instruction manual

intended function correctly. If in doubt, the part should be renewed. Damage to

moving parts or major components should be Inspected by a qualified technician

before operating the machine. Contact your local dealer for advice.

19. DO NOT STAND ON THE MACHINE. Serious injury could occur if the machine is

tipped over. Do not store materials above or near the machine such that it is

necessary to stand on the machine to get to them.

20. NEVER operate a machine when under the influence of alcohol, drugs or

medication.

21. ALWAYS ENSURE THAT ADEQUATE LIGHTING is available. A minimum intensity

of 300 lux should be provided. Ensure that lighting is placed so that you will not

be working in your own shadow.

ADDITIONAL SAFETY RULES FOR METAL CUT-OFF SAWS

WARNING!

THIS MACHINE MUST NOT BE MODIFIED, OR USED FOR ANY PURPOSE

OTHER THAN THAT FOR WHICH IT

IS DESIGNED.

1. IMPORTANT: You should not operate this machine unless you are thoroughly

familiar with metal cutting saws. If there is any doubt whatsoever, you should

consult a qualified person.

2. Do not operate the machine until it is completely assembled, and this entire

manual, has been read and understood.

3. Ensure the proper electrical regulations are followed.

4. Ensure the abrasive disk is securely mounted in accordance with these

instructions, before connecting to a power supply.

5. DO NOT over tighten the abrasive disk. This can cause stress, and could lead

to the wheel shattering when under load.

6. Always check the abrasive disk for cracks before use.

7. Before switching the machine on, ALWAYS ensure the work is properly

secured, ALWAYS use the vice, NEVER hand hold a workpiece.

8. Make all adjustments with the power OFF.

9. When starting a cut, always ease the tool into the work. A harsh or sudden

impact could shatter the abrasive disk.

10. Ensure the Abrasive Disk reaches maximum speed before beginning a cut.

11. Never use the machine with the guards removed.

12. Ensure you use the correct type of Abrasive Disk for the type of material

being cut. Metal cutting & masonry Abrasive Disks are available from your

Clarke dealer. NEVER cut magnesium, wood, or non-ferrous metals.