Instruction manual

ASSEMBLY

CAUTION!

IT IS ADVISED THAT ASSISTANCE BE USED WHEN ASSEMBLING THIS MACHINE.

A. Column to the Base.

C. Head to Column.

NOTE: I

t may be necessary to unscrew the Head Lock Set

Screws (A fig.2), to ensure they do not protrude internally,

as this would prevent the head from sliding fully into

position.

1. With assistance, raise the Head, and locate it on top

of the Column, ensuring it slides home fully.

2. Align the head with the base, and tighten down the

Head Lock Set Screws using the wrench provided, to

secure the head.

3. Locate the three feed handles, and screw them

firmly into the hub of the feed shaft.

Fig. 2

Fig. 3

Fig. 1

Bolt the column assembly to the base with the four M8 x

20mm hex. screws provided.

NOTE:

Ideally, the base with column attached, should be

firmly bolted to the workbench, prior to the assembly of

other components.

B. Table to Column.

1. Thread the Table Support Locking Handle into the

Table Support from the left hand side, and leave it

loose at this stage.

2. Slide the Table Support with Table, over the Column,

and lower it so that it rests against the column

support bracket (Fig. 1). Nip up the locking handle to

prevent the table from swinging freely during the

assembly process.

3. Check to ensure the column set screws, at the

column support, are tight