Operating instructions

11
Parts & Service: 020 8988 7400 / E-mail: [e-mail] or [e-mail]
LOCKING / RELEASING THE SAW HEAD
1. Press down slightly on the
operating handle and pull out the
Head Lock Pin, and rotate it 90
degrees as shown.
2. Gently release the downward
pressure on the operating handle
and allow the head to rise to its
full height.
FITTING THE WORK CLAMP
1. Loosen the thumb screw on either
of the clamp supports.
2. Slide the work clamp into the
clamp supports.
3. Tighten the thumb screw to
secure the work clamp.