Operating instructions

16
Parts & Service: 020 8988 7400 / E-mail: [e-mail] or [e-mail]
BEVEL CUTS
Bevel angles can be set from 45° left to vertical and can be cut with the mitre
arm set between zero and a maximum of 45° mitre position right or left.
1. Loosen the bevel adjustment
handle and set the bevel at the
desired angle.
2. Tighten the bevel adjustment
handle firmly.
3. Proceed as for a vertical straight
cross-cut.
• Allow the blade to cut freely.
Do not force the tool.
MITRE / BEVEL CUTS
As the number of sides changes, so do the mitre and bevel angles. The chart
below gives the cutting angles for a variety of shapes, assuming that all sides
are of equal length.
COMPOUND MITRE CUTS
A compound mitre is a cut made using a mitre angle and a bevel angle at the
same time. This is the type of cut used to make frames or boxes with slanting
sides.
1. Set your saw to the required
angles and make a few trial cuts.
2. Practice fitting the cut pieces
together.
3. Always try cuts on a few scrap
pieces of wood to verify the
settings on the saw.
No. of sides Angle mitre or bevel
4 45°
5 36°
6 30°
7 25.7°
8 22.5°
9 20°
10 18°