Specifications

MAINTENANCE
WARNING
Before checking the condition of the pump, ensure it is unplugged from the
mains supply. If the unit is hard wired, ensure the circuit breaker is open.
Check the pump installation regularly to ensure the base inlet is clear of leaves or
other debris.
Note that these pumps are fitted with automatic thermal overload protection. If
the pump overheats due to an obstruction in the pump, or pumping warm water
in excess of 50
o
C for example, it will shut off automatically. Switch the pump OFF
and disconnect from the mains supply. Check for blockages and allow the motor
to cool (at least 15 minutes) before attempting to restart.
These pumps should require no maintenance other than regular cleaning. If the
pump starts to show signs of wear or damage, contact your CLARKE dealer for
advice. Do not use the pump if there is any damage to the mains supply cable, or
to the float switch or its cable.
Do not attempt to repair the pump yourself, as you may damage the waterproof
seal and invalidate your guarantee. Repairs must be carried out by your CLARKE
dealer, or contact the CLARKE Service Department, on 0208 556 4443.
If the pump becomes badly clogged, the stainless steel strainer may be removed
and cleaned by removing the screws, on the underside of the strainer, which
secure it to the main body.
Back flush the pump by removing the inlet hose adapter and directing a jet of
clean water through the inlet port.
7
IMPORTANT
Do not attempt to strip the pump further as this will invalidate the guarantee