Owner`s manual

4
Parts & Service: 020 8988 7400 / E-mail: [e-mail] or [e-mail]
13. Before use, carefully check the tool
and mains cable for damage or
any other conditions that may
affect its operation. Do not use the
tool if any part is damaged or
defective.
14. Do not use the tool if the switch
does not turn it on and off.
15. Remove adjusting keys and
wrenches. Form the habit of
checking to see that keys and
adjusting wrenches are removed
from the tool before turning it on.
16. Use the right tool - Do not force
small tools to do the job of a heavy
duty tool. It will do the job better
and safer at the rate for which it
was intended. Do not use tools for
purposes not intended; for
example do not use table saws to
cut tree limbs or logs.
17. Do not overreach - Keep proper
footing and balance at all times.
18. Connect table saws to a dust-
collecting device when sawing
wood.
19. The use of any accessory or
attachment other than one
recommended in this instruction
manual may present a risk of
personal injury.
20. Guard against electric shock -
Avoid body contact with earthed
or grounded surfaces (e.g. pipes,
radiators, ranges, refrigerators).
21. Extension cables - Before use,
inspect the extension cable and
replace if damaged. When using
the tool outdoors, only use
extension cables intended for
outdoor use and marked
accordingly.
22. Avoid unintentional starting, Make
certain the switch is in the OFF
position before connecting the
machine to the power supply.
23. Don't abuse the cable. Never yank
the cable to disconnect from the
mains supply. Keep the cable
away from heat, oil, water and
sharp edges.
24. This table saw is designed and
intended for use by properly
trained and experienced
personnel only. If you are not
familiar with the proper and safe
operation of a table saw, do not
use until proper training and
knowledge have been obtained.
25. Stay alert, watch what you are
doing. Use common sense. Do not
operate the tool when you are
tired.
26. Do not operate this machine while
tired or under the influence of
drugs, alcohol or any medication.
27. Keep hands out of the line of saw
blade.
28. Maintain a balanced stance at all
times so that you do not fall on to
the blade or other moving parts.
Do not overreach or use excessive
force to perform any machine
operation.
29. Use push-sticks or push blocks to
feed the workpiece past the saw
blade. Keep your hands and
fingers well away from the blade.
30. The push-stick should always be
stored with the machine when not
in use.
31. Pay particular attention to
instructions on reducing risk of
kickback.