Owner`s manual

15
Parts & Service: 020 8988 7400 / E-mail: [e-mail] or [e-mail]
BEFORE STARTING WORK
• All covers and safety devices have to be properly fitted before the
machine is switched on.
• When working with wood that has been used before, remove all
foreign bodies such as nails or screws etc before cutting.
• Before you switch on, make sure that the saw blade is correctly fitted
and that the machine's moving parts run smoothly.
• Before you connect the machine to the power supply, make sure
the data on the rating plate is the same as that for your mains
supply.
ADJUSTMENTS
After every new adjustment, we recommend you to make a trial cut in order
to check the new settings.
PARALLEL FENCE
CUTTING WIDTH
The parallel fence can be mounted on either side of the saw table. If you
change the side, you will need to move the parallel fence to the other side of
the holder.
1. Slide the parallel fence into the
guide rail of the saw table.
2. Use the scale on the guide rail to
set the parallel fence to the
required distance from the blade.
3. Lock the parallel fence in the
required position by pressing
down on the lever.