Owner`s manual

19
Parts & Service: 020 8988 7400 / E-mail: [e-mail] or [e-mail]
6. Always push the workpiece through to the end of the riving knife using a
push stick.
7. Do not remove the offcut piece until the blade has stopped spinning.
8. Secure long workpieces against falling off at the end of the cut (e.g. with a
roller stand etc.).
CUTTING NARROW WORKPIECES
Always use a push stick when the
workpiece is smaller then 120 mm in
width.
When not in use, place the push stick
in its storage clip on the side of the
saw.
Replace a worn or damaged push
stick immediately.
BEVEL CUTS
Bevel cuts must always be made using the parallel fence.
1. Undo the bevel lock.
2. Turn the bevel adjustment to set
the desired angle on the scale.
3. Tighten the bevel lock to lock the
blade at the selected angle.
4. Set the parallel fence.
5. Perform the cut as you would for
a ripping cut.